Before you connect the equipment to the power outlet, please check the voltage of the power source. Table Of Contents 1. All printers excluding printheads are warranted against defect in material or workmanship for twelve 12 months from the invoice date. The printer will go back to standby mode after printing a Self-Test page. When printing with continuous media, when pressing the Feed key, the printer will feed media out to a certain length. No other warranties, expressed or implied, are given. Ideally suited to high-volume printing, harsh environments and applications where very fine detail print is required.
|Date Added:||7 March 2012|
|File Size:||69.2 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Select the icon of driver file and click it to start the installation. Printer Installation This printer model has the following print modes: Follow the instruction on screen to keep the installation going.
Usb Uninstallation Take the power cable, plug the cable switch to the power socket, and then connect the other end of the cable to the printer power socket. Other Products in ‘Godex Barcode Printers’ category. Data Terminal Equipment Printer Page Adjustable reflective sensor and transmissive sensor, left aligned.
Got it, continue to print. Hold the cutter module and lock it with screws After the screws are locked, flip to close the cutter module. Remove the Ethernet Module and its connection wire.
Godex Print Head, 203 dpi for EZ-DT-4E/DT4X/EZPi-1200,
Open the top cover by pressing the Cover Open Buttons on both sides. Place the left side of the stripper first, and then fit the right side.
Peel off the first label, and feed the liner through the roller and the peel off bracket. Take off the media roll spindle.
Print Line Adjustment To get better printing balance and quality, gosex print head adjusting gear to adjust the contacting surface between print head and label. LCD will show the second Variable Prompt. Please power off the printer before installing the cutter module. When goddx labels, pressing the Feed key, the printer will feed one label at a time; if the label is not sent out in a correct position, then please proceed with the Auto Sensing see page To print the manual completely, please, download it.
Godex Print head dpi for Godex EZ-DT-4E/ EZPi
Then the Driver Wizard utility should run automatically. Don’t show me this message again.
DB9 female, 12200 assignment is as follows: Label Roll Core Installation Instruction Comments to this Manuals Your Name. Thermal Transfer TT When printing, ribbon must be installed to transfer the print contents onto the media. Wlan Module Installation This manual also for: Page 5 Warranty Exclusions and Conditions Statement The warranties provided above are the only warranties applicable.
Disconnect the equipment from the goddex of the power source to prevent possible transient over voltage damage. Unscrew the Ethernet Module Secure Screw.
Thermal Transfer Label Printer Godex ZXi / ZXi / ZXi
Printer Parts Please use the following diagrams to identify each printer part. When printing, no ribbon is necessary; it only requires direct thermal media. This manual also for: Place the right side in first, and then fit the left side. Hold the cutter module and lock it with the two side screws Compact but high-performace range of 4-inch wide desktop printers for low to medium volume printing.