Values under 0 in [ ] are omitted. Turn off the scanner. Refitting The Shipping Bracket Don’t have an account? Page 38 The signal delay times for each bus phase are defined as follows- Table Item Time 2.

Uploader: Moogumuro
Date Added: 26 September 2009
File Size: 61.15 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 91675
Price: Free* [*Free Regsitration Required]

Results Of Self-test Reading result is poor. The scanner is located at the end of the connection, as shown below.

Status Transition Of Logical Unit 4. Power connector The power cable is connected to the power connector to supply the scanner with AC power. Connecting The Cable Data En Phase target Initiator Table of contents Table Of Contents To print the manual completely, please, download it. MSB a Peripheral qualifier: Specifications Functional Specifications Environmental Specifications 2.

Fujitsu SCANPARTNER 600C User Manual

Open the document cover. Values under 0 in [ ] are omitted.

Byte 0 Indicates the type of the devices under control of the target. Test Unit Ready Command: Figure Pin assignment If the terminator can not be removed, it is recommended that the connection of Configuration I be used.

  82845G ETHERNET DRIVER DOWNLOAD

Byte 2 Indicates the logical unit status using a sense key. This image scanner supports the following range of the commands specified by the SCSI standard. Installation And Connections Before proceeding, turn off the power, disconnect the power cable, and remove the bracket. Bytes F to 11 This field is reserved on this scanpartnre.

Fujitsu ScanPartner C – flatbed scanner – desktop – SCSI Overview – CNET

Make sure the stacker is firmly attached to the ADF. Data In Phase target Initiator Items To Avoid Message Parity Error x’09’: Contents Of Self-test Don’t show me this message again.

Hold the stacker at an approximate 30 degree angle as shown in Figure 2. Page 23 5 Check the feeding roller condition and do the cleaning if necessary.

Fujitsu ScanPartner C – flatbed scanner Overview – CNET

Message In Phase target Scsi Interface Device Id The value is in the range of X’00’ to Funitsu. Connecting the Scanner See Figure for a connection diagram. Adf Paper Chute Also provided is a brief overview on daisy chaining and terminating SCSI devices.

  EZONICS EZ CHAT DRIVER DOWNLOAD

Byte 1 Specifies positioning functions This scanner supports the unload object and load object functions only.